The SHS Solar Controller is a low cost yet reliable solar regulator with many features and benefits.
Available in two sizes: 6A for solar panels up to 85 watts, 10A for solar panels up to 150 watts

Features

• Low Cost - The SHS was specifically designed to meet the needs of the rural electrification market. The low cost resulted from using the latest electronic technology and high volume manufacturing.
• high Reliability - All our controllers are designed for high quality and high reliability. The SHS controller is 100% solid state, has a low failure rate and will last a long time.
• Electronic protections - The SHS has built-in electronic fuses that do not require replacement. Any wiring mistakes during installation will not damage the controller.
• Tropicalization - The SHS electronics are protected with a moisture-tight coating, minimizing damage from humidity and from nesting insects.
• Easy to use - The SHS controller is fully automatic and requires no adjustments or user selections.

Benefits of the SHS Solar Regulator

• Reduces Cost of Battery Replacements
• The low voltage disconnect will increase battery life. The loads are automatically disconnected when the battery is low and automatically reconnected after the battery is recharged.
• Complete charging will increase battery life and storage capacity.
• The controller will maximize the amount of solar energy into the battery and avoid drying out the battery.
• LEDs display status information and battery level which helps the user to better operate the solar power system.

Specifications

• For 12 Volt systems
• SHS-6 85 WATTS OR 6 AMPS FOR SOLAR AND LOAD
• SHS-10 150 WATTS OR 10 AMPS FOR SOLAR AND LOAD
• Regulation Point 14.3 Volts
• Low voltage Disconnect 11.5 Volts
• Low voltage Reconnect 12.6 Volts
• Type of Charging Series PWM
• 4 Stage: Bulk, PWM, Boost and Float
• Temperature compensated charging
• Electronic Protections: Short circuit and overcurrent Protection for solar and load; Reverse polarity Protection for solar / load / battery; Reverse current Protection at night; High voltage Protection for load
• Tropicalization: Circuit Board conformal coated and Terminals corrosion protected
• LED Indications: Green for charging, Green-Yellow-Red for battery levels, Red lfor ow voltage warning and disconnect, All 3 LEDs blink to show mistakes
• Terminals For wire sizes to 4 mm2
• Dimensions 15.1 x 6.6 x 3.6 cm
• Weight 113 g
• Self-consumption 8 mA maximum
• Temperature –25°C to +50°C
• Humidity 100% non-condensing
• Enclosure IP 22
• Compliance CE, World Bank

Morningstar SHS manual (PDF File)